This is what you need:
printer
paper
scissors
glue
cocktail stick
cupcake
How to make this cupcake topper:
1. Print the cut-out and cut all parts roughly (fig. 1).
Making the clown:
2. Double the design of the clown at the dotted lines harmonicawise (fig. 2, 3).
3. Flatten the design again but keep dubbled on the middel dotted line. Cut out the round ends of the clown (fig. 4).
4. Open the clown, put glue on the back of the clown but not on the two half circles at the end of the clown (fig. 5).
5. Put the stick in the right place and glue the clown together (fig. 6).
6. Cut out the clown (fig. 7).
Making the circle:
7. Double the design of the circle at the dotted line and glue the parts together. Cut out the circle and pierce a little hole in it (fig. 8,9,10).
Assemble the topper:
8. Take the clown and put glue on the bottom of the circle (fig 11).
9. Run the stick with the clown trough the little hole in the yellow/red circle and glue them together (fig 12). Now it is ready to be put on the cupcake.
Photo instruction:
