This is what you need:
printer
paper
scissors
glue
cocktail stick
cupcake
How to make this cupcake topper:
1. Print the cut-out and cut all parts roughly (fig. 1).
Making the ringmaster:
2. Double the design of the ringmaster at the dotted lines harmonicawise (fig. 2, 3).
3. Flatten the design again but keep dubbled on the middle dotted line. Cut out the round ends of the ringmaster (fig. 4).
4. Open the ringmaster, put glue on the back of the ringmaster but not on the two half circles at the end of the ringmaster (fig. 5).
5. Put the stick in the right place and glue the ringmaster together (fig. 6).
6. Cut out the clown (fig. 7).
Making the circle:
7. Double the design of the circle at the dotted line and glue the parts together. Cut out the circle and pierce a little hole in the middle of the circle (fig. 8,9,10).
Assemble the topper:
8. Take the ringmaster and put glue on the bottom of the circle . Run the stick with the clown trough the little hole in the yellow/red circle and glue them together (fig 11). Now it is ready to be put on the cupcake (fig 12).